Do not put your hands over or in line with the blade. Do not use the fence and the miter gauge at the same time. This will likely cause the board to bind, jump, or kick back. Do not push the material into the fence too hard. It isn't necessary and also spring loads the fence. You will not get an accurate cut and greatly increase to risk of the board jumping or a kick back. Do not saw the push sticks and blocks. If it happens it is better than your fingers; that is why they are there. That said, if you are hitting them, you are not using the proper one or using it improperly. These also take material and time to make. Do not put your hands over or in line with the blade. Check you material for metal. Never allow an inexperienced person to operate this equipment. Members use a large amount of recycled wood and a nail in the wood is not unimaginable. Metal and table saw blades do not mix. It is dangerous and even if you make it out unscathed it will absolutely damage the tool. Do retract the blade into the table when finished. It hides the blade in case someone trips in the shop and catches themselves on the table saw. There is no reason not to do this. Do use push sticks and blocks. There are occasions where using a push stick/block are not necessary, and there are rare occasions when using them can be dangerous. But in general, when in doubt use them. Use co mm on sense. If you think wow this is going to bring my hands uncomfortably close to the blade grab a stick. Clean up after yourself. Not only is it good shop etiquette, but having measuring tools or scrap wood vibrating around on the table or top of the fence while cutting is potentially dangerous.

- If we deliver you must phone for collection please - we do not automatically collect.
- Machines are not insured, if not returned you will need to pay for the full replacement.
- Make sure you know how to use the tools. Ask if you need help, our friendly staff will assist. Also, make sure of safety requirements.
- Hires are charged for time out – not time used. Minimum 1 day (1 day = 24 hrs)
- Scaffold is charged weekly, all other tools daily.
- Tools must be returned Clean please. e.g., if you paint onto a ladder, we charge for cleaning.
- Negligent damages get charged separately.
- Consumables not used, may be returned for refund.
- Only use heavy-duty extension leads, not thin household leads.
- If you pay by cash we can refund in cash, if you pay by card we refund onto the card. (we can't refund onto debit cards) - Card refunds can take up to 10 days.
- Weekend hire starts after 2 pm Friday until 9 am Monday = 1day charge. ( Sundays are free) If you are late on Monday it is for 2 days.
- If you keep machines for a long time we can give you a better rate, discuss with your hire controller in store.

Specifications
Continuous rating input 1,500W
Max cutting capacity 0 degrees: 91mm 45 degrees: 63mm
Blade diameter 255mm
No load speed (r/min) 4,300r/min
Dimensions (LxWxH) 726x984x333mm
Net weight 34.1kg
Power supply cord 2.5m